You can use Overlay Traces from the Graph menu. In order to compare the three results, merge the plots in one. You will see the critically damped response. Note: If you connect the Oscilloscope to the circuit and run the simulation, a similar analysis is performed.
Results are displayed in Figure 4.Īs you can see, this is the typical underdamped response of a series RLC circuit.
You can reset all the parameters to their default values by clicking the Reset to default button.įigure 2. Analysis parameters for the Transient Analysis.
If the simulation fails, it uses user-defined initial conditions. Multisim tries to start the simulation using the DC operating point as the initial condition.